(800) 991-3350  ●  (631) 389-2138

RODE VideoMic Pro-R Condenser Microphone Rycote Lyre Shockmount Watch Video

RODE VideoMic Pro-R Condenser Microphone Rycote Lyre Shockmount

Product Code:

VideoMic Pro-R
Brand New USA
Out Of Stock
Average Rating:

Our Price:
List Price:
You Save (29%):
Free shipping on dozens of digital cameras Special offers


RODE VideoMic Pro-R Condenser Microphone Rycote Lyre Shockmount with:

RODE VideoMic Pro-R Condenser Microphone with Rycote Lyre Shockmount

Capture high-quality audio directly from the source.

Compact and lightweight by design, the RODE VideoMic Pro is a true shotgun microphone designed for use with camcorders, DSLR cameras and portable audio recorders as a source of primary and reference audio.

At the heart of the VideoMic Pro is an all-new 1/2" condenser capsule that provides broadcast-quality audio via a 3.5mm minijack connector (outputting the mono signal to both left and right channels) with an incredibly low self-noise of just 14db. A super-cardioid polar pattern ensures that surrounding audio is minimized, and your recording is focused on the subject in front of the camera.

The integrated Rycote Lyre based shock mounting system separates the VideoMic Pro capsule and electronics from its mount, providing isolation from external physical factors that may cause unwanted rumble and vibrations in the microphone. Constructed from a single piece of hard-wearing thermoplastic, the Lyre provides superior acoustic suspension to traditional elastic solutions, and will never wear out, sag or snap. Easily accessible on the rear face of the microphone are the power, filter and level controls. In addition to the microphone's native 40Hz-20kHz response, a selectable high-pass filter at 80Hz is available, which will prevent low end noise such as air conditioners and traffic from being recorded.

Below these controls are the level settings, which attenuate or boost the recorded level as required. The -10dB level attenuation (or PAD) is ideal for recording loud sound sources, such as live music, motorsport, or interviews where the subject is very close to the camera. The +20dB level boost is designed for use with DSLR cameras, allowing the user to reduce the camera's preamp level (or mic-input level), effectively reducing the amount of noise generated by the camera's comparatively low quality audio circuitry.

The microphone uses a standard sized shoe mount for on camera use, and features a 3/8" thread in the base of the mount for easy boom pole mounting. The VideoMic pro is battery powered, and provides over 70 hours of recording from a single 9V battery.


Key Features:

  • High-quality condenser microphone
  • All-new capsule with lower noise and higher sensitivity
  • Integrated Rycote Lyre shock mounting
  • Two-step High Pass Filter (flat, 80Hz)
  • Three position level control (-10dB, 0, +20dB)
  • Rugged, reinforced ABS construction
  • Compact, lightweight design (85g)
  • 3.5mm stereo mini-jack output (dual mono)
  • Integrated cold-shoe mount with 3/8" thread
  • Integrated foam windscreen
  • 9V battery powered - over 70 hours use (alkaline)
0 accessories found for RODE VideoMic Pro-R Condenser Microphone Rycote Lyre Shockmount
RODE VideoMic Pro-R Microphone

Acoustic Principle: Line Gradient
Active Electronics: JFET impedance converter
Capsule: 0.50"
Output Impedance: 200 ohms
Polar Pattern: Supercardioid
Address Type: End
Frequency Range: 40Hz - 20kHz (selected HPF @80)
Maximum SPL: 134 dB SPL 1%
Sensitivity: -32.0dB re 1 Volt / Pascal (20mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Level Control: Three-position (-10 dB, 0, +20 dB)
High Pass Filter: Two-step (flat, 80 Hz)
Output: 3.5mm TRS
Equivalent Noise Level (A-weighted) : 14dB-A
Power: 9V alkaline battery
Dimensions (WxHxD): 2.9 x 3.9 x 6.6 in. (75 x 100 x 170mm)
Weight: 3.0 oz. (85g)
Share this deal on Facebook
Share this deal on Twitter
Share this deal on Pinterest